Full Race Catch Can Kit (2 Port) for 2015+ Ford F-150 2.7L and 3.5L V6 Ecoboost and 2017+ Raptor 3.5L Ecoboost
When it comes to Ford's turbocharged Ecoboost engines, no discussion creates more debate than Catch Can and PCV configuration. Turbocharged Direct Injection engines inherently have a greater amount of “blow-by” that doesn't get washed off the valves and cylinders like a port injection engine. How do you avoid this issue to begin with? You need a good quality catch can, located between the valve covers and the turbocharger inlet.
Now you may ask, "What's wrong with the factory PCV system?" The PCV valve is used to vent crankcase fumes, while the engine is out of boost. Once the engine is in boost, the PCV should shut and all pressure gets routed through the one valve cover, venting crankcase vapors into the turbo inlet. The PCV is only a simple vent hose with check valve, located between the valve cover and intake manifold plenum. All PCV check valves are designed to open during vacuum/light throttle/decel and shut during boost, sealing the system. The crankcase vent air that escapes through the PCV contains oil vapor, water vapor and other combustion byproduct gases. That vapor normally ends up in your intake tract and most of it gets burned. The rest of it collects on the inside of the intake manifold, the intake ports, and the back of your intake valves, baking on over time to create a hard tar-like carbon buildup. On a turbocharged engine, a dirty or clogged PCV valve can affect performance and fuel economy: PCV valves may leak with a few thousand miles of baked on oil crud. If stuck slightly open, boost from the IM can enter the crankcase, causing a loss of power.
Don't recirculate the oil and risk your engine's clean oil supply. The liquid that collected in the can isn't just oil; it also contains all sorts of combustion by-products that have made it past the piston rings, as well as liquid water which condenses as the hot gases hit the relatively cool can. So, now sitting in the bottom of the catch can is a mix of hydrocarbons (raw fuel and other vile things), water, and oil. This should not be part of your engine’s clean oil supply.
Catch Can Kit Features
- Hand-fabricated, TIG-welded by professionals
- Stops oil from entering intake manifold
- "Plug and Play" Direct replacement, so no tuning required.
- Completely bolt on. No cutting or permanent modification needed.
- All fittings and lines needed for installation are included
NOTE: This item is built to order and can take up to one month to ship.
- 2015, 2016, 2017, 2018, 2019, 2020 Ford F150 2.7L Ecoboost
- 2015, 2016, 2017, 2018, 2018, 2020 Ford F150 3.5L Ecoboost
- 2017, 2018, 2019, 2020 Ford Raptor 3.5L Ecoboost